Wire harness machine can cut and strip the cable at a fixed length, then put on the terminal and insert harness into rubber connector to form the wire harness. Due to the different design structure, the wire circuit is composed of wire to wire and wire to circuit board. Automatic wire harness machine is widely used in home appliance wire harness and automotive wire harness processing industry.

Automatic Terminal Crimping and Cable Harness Insertion Machine

Attention must be paid to the use of wire harness machine.

The matters that must be followed in the installation, operation, inspection and adjustment of the automatic wire harness machine, please note.

1. The power supply must be reliably grounded. In addition, in the event of electrical failure, the injury to the operator such as electric shock can be avoided and the loss can be reduced to a minimum.

2. For safety reasons, when installing the chassis cover, it is not allowed to start the device without reliable locking or removal. When the chassis cover needs to be removed due to maintenance and other reasons, the power supply must be cut off first, and the gas source is insufficient before maintenance and other operations can be carried out.

3. When the wire harness machine is running automatically, do not put your hands in the moving position or between the terminal modules. If necessary, we should first stop the operation of wire harness machine, cut off the power, or start working after unplugging. Failure to follow the above principles and come into contact with the machine may lead to accidents.

Cable Harness Assembly Processing

4. Repair by more than two people, the maintenance must be greeted each other, to confirm safety, while carrying out maintenance.

5. In order to replace (wires, posts, terminal moulds, etc.) or clean, when we put your hand into the host body, the power supply must be cut off and the air source can be carried out.

6. When the terminal is broken down, the power of the connector must be disconnected and operated with tools such as tweezers. Do not put your hand directly into the connector and remove it.

7. Programmable controllers, sensors, drivers and other electrical appliances cannot be touched at will, otherwise the wire harness machine may get out of control and cause accidents.

Standard Crimping Mould Applicator

The characteristics of automatic wire harness machine.

1. International personalized design, the overall structure is solid and generous.

2. The use of industrial control computer operating system, the operation interface is simple and reasonable, can quickly grasp the operation of wire harness machine. All parameters can be easily set and stored. The operation instructions are intuitive and simple.

3. Using real-time network bus system, high control precision, fast response, good stability and simple wiring.

4. The wire harness machine adopts a series of motors with high crimping precision and strong stability.

High Quality Terminal Crimping Machine

5. Automatically adjust the crimping height of the die to fully realize automatic operation.

6. The full closed loop wire feeding system and synchronous belt feeding device are adopted to ensure no damage to the wire surface and improve the wire feeding accuracy.

7. Data management and storage optional QR code gun and QR code printer.

8. Unqualified products can be removed and recycled directly.