Terminal crimping machine is a kind of precision wire harness processing equipment, but the speed adjustment of terminal machine is not a very difficult technology, but it still requires terminal machine maintainers to accumulate some experience and become familiar with it very quickly. We must remember that this fine-tuning does not have a standard value, but needs to be adjusted according to the specific conditions of wire harness production at that time.

For the automatic terminal crimping machine, the most convenient place is that the adjustment parameters are very flexible and can be operated by front-line staff.
What JMK is going to talk about today is how to adjust the speed of a fully automatic terminal crimping machine.

Fully Automatic Terminal Crimping Machine

1.Look at the adjustment range.

The speed of each terminal crimping machine has a certain range, neither too slow nor too fast, and such important parameters are usually listed in the manual, such as the insertion speed of the JM-601A and JM-601B pressed at both ends is 1.8s / strip, and the rubber seat exchange is 2.4s.

2.Adjust by combining wire harness and terminal material.

Specific adjustment also needs to refer to the fully automatic terminal crimping machine wire tension comparison table and terminal pressure gauge, the specific adjustment of terminal pressure can refer to the "automatic terminal crimping machine pressure testing steps".

3.Make fine-tuning.

After step 2, we get a relatively accurate adjustment speed, but for accurate adjustment, we still need to fine-tune to achieve a satisfactory state, which requires terminal machine technicians to make micro-adjustments slowly.When you are satisfied with the speed of the adjustment, you can switch to the mass production mode and give it to the front-line staff to continue the operation.

Any how, it is not a very difficult technology to adjust the speed of a fully automatic terminal crimping machine, but it still requires terminal crimping machine maintenance personnel to accumulate some experience and become familiar with it very quickly. We must remember that there is no standard value for this fine-tuning, but it needs to be adjusted according to the specific conditions of wire harness production at that time.