Terminal insertion machine is equipment with a very high degree of automation, and its main features are to do wire crimping and terminal insert housing. However, according to the actual needs, there are more coherent automated processes, but they can not be fully reflected in the name. Although the fully automatic plastic connector terminal insertion machine has a variety of advantages, it is after all mechanical equipment, and some problems will inevitably be encountered in the course of use. Here is JMK to introduce the four major reasons why the fixed terminal of the automatic plastic connector terminal insertion machine is abnormal:

4 reasons for defective output by terminal insertion machine

1. Poor appearance caused by coating peeling, corrosion, bruising, flying edge of plastic connector, rupture, rough processing of contact parts, deformation and so on.

2. The poor interchange caused by the poor positioning and locking fit size of the automatic rubber shell piercing machine, poor consistency of processing quality, excessive total separation force and so on.

3. Due to material, design, technology and other reasons, the abnormal separation between plug and socket, pin and Jack caused by unreliable structure will result in the interruption of electromechanical energy transmission and signal control in the control system.

4. Due to unreliable design, wrong material selection, improper selection of forming process, poor quality of heat treatment, mold, assembly, welding and other process quality of automatic rubber shell piercing machine, poor assembly and poor assembly will lead to poor fixation.

The above are the four major reasons for the use of automatic plastic connector terminal insertion machine to produce defective products, only after we have a deep understanding, can we pay attention to these aspects, reduce the failure rate as far as possible, and put an end to the occurrence of defective products!