Wire crimping machine is a common one-time machine in modern society, which is equipped with automatic air blowing and oil feeding device, which can reduce the phenomenon of waste blockage, prolong the service life of blades, and increase the output of wire stripping terminals. Create benefits for enterprises.

So what are the correct methods and precautions for the use of the wire crimping machine?

The impact of wire crimping machine is very strong, so you should be careful when operating. The correct operation steps of the terminal machine are as follows:

1. Turn on the power switch of wire crimping machine and the power indicator light is on.

2. Pay attention to whether there is any obvious abnormal noise inside and outside the machine. if there is a suspension of operation, please ask the mechanic to determine whether maintenance is needed.

3. Knife selection and knife loading: operated by designated personnel, manual comparison must be carried out before the knife is installed, and the knife can be installed only after the comparison is correct. After the knife installation is completed, manual testing must be used.

First of all, turn off the power of wire crimping machine, press the down button, and use a special wrench to shake the main driven wheel to maximize the stamping stroke of the terminal machine. If the hand does not shake, consider whether the pressure is too high or other problems, check and debug to OK.

Second, Check the locking screws and make sure there is no loosening before operation.

4. Loading: install the terminal that needs to be hit, use the inner hexagonal wrench to adjust the feed pressure plate, so that the terminal can pass easily, and visually see whether the feeding position is suitable, if not, adjust it, use the hexagonal wrench to loosen the feeder locking screw, screw the adjusting screw to adjust to the best condition, then lock the feeder locking screw and start the operation.

5. Test tension: after adjusting the OK, take the waste wire to try and test the tension. The main reference value can be seen in the "tension Test comparison Table". The specific operation methods are as follows: press the tension test return key to zero, clip the terminal wire to be tested, and test it. If the measured tension is not within the standard range, please re-adjust the machine repair personnel until the standard value is reached.

6. The trial production 10pcs sends the IPQC to confirm the first piece and check the OK before mass production. During the production process, the operator must check whether the terminal is covered with glue, neck hanging and other defects, and carry out the terminal tension test every 1 hour.