Wide application of automatic terminal crimping machine

Automatic terminal crimping machine has been used in various industries, not only can accurately complete the terminal crimping work, but also can save manpower and material resources, the effect of production efficiency. Especially in the rapid development of new energy automotive industry and home appliance industry, automatic crimping machine have attracted more and more attention because of their superior performance.

The Correct Operation Method of Automatic Crimping Machine

1. Turn on the power switch of the terminal machine, and use it only when the power indicator light is on. 

2. Pay attention to whether there is any obvious abnormal noise inside and outside the machine. if there is a suspension of operation, please stop the machine, and ask the mechanic to determine whether maintenance is needed. 

3. Carefully select the knife to install the knife: 

operated by the designated personnel, the selected blade must be manually compared before the knife is installed, and the knife can be installed after the comparison is correct. after the knife installation is completed, you must use manual testing, first turn off the power supply of the terminal machine, press the down-adjustment button, and use a special board hand to shake the main follower wheel to maximize the stamping stroke of the terminal machine. If the hand does not move, consider whether the pressure is too high or other problems, check and debug to OK. Check the locking screws and make sure there is no loosening before operation. 

4. pay attention to loading:

Install the terminal that needs to be hit, use the inner hexagonal plate hand to adjust the feed pressure plate, so that the terminal can pass easily, and visually see whether the feeding position is suitable, if not, adjust it, use the inner hexagonal plate hand to loosen the feeder locking screw, twist the adjusting lever to adjust to the best condition, and then lock the feeder locking screw to start the operation. 

5. test tension:

after adjusting the OK, take the waste wire to try and test the tension. The main reference value can be seen in the "tension Test comparison Table". The specific operation methods are as follows: press the tension test return key to zero, clip the terminal wire to be tested, and test it. If the measured tension is not within the standard range, please re-adjust the machine repair personnel until the standard value is reached.

6. The trial production 10PCS will send IPQC to confirm the first piece and check the OK before mass production. During the production process, the operator must check whether the terminal is covered with glue, neck hanging and other defects, and carry out the terminal tension test every 1 hour.

7. After the completion of production, sort out the good products, waste and inferior products, and clean up the environmental hygiene around the machine.